5. OPERATION
Risk of death by electrocution or electric shock or serious personal
injury if power lines or electric cords are contacted. Never operate
mower over electrical sources, cords, or wires.
DANGER! Risk of injury due to electric shock.
Warning! Do not plug in before installation is fully completed!
Caution! Do not touch rotating blade!
Set up the lawn mower on at and rm ground to ensure safe and sturdy operating.
Put the upper handle
3
horizontally on the ground,then open the quick clamp
5
of the
lower handle
9
.
Move the lower handle
9
to the proper gear.Tighten the quick clamp
5
to secure the lower
handle
9
.Align the hole location of the upper handle
3
to the lower handle
9
. Assemble
it with a quick clamp
5
, then fasten the clamp.
Attach the power cord to the upper handle
3
with a wire clip
4
.
Setting up your lawn mower
There are three dierent handle gears on the side of the lower handle
9
to vary the height.
If the height seems too tall or too short, open the quick clamp
5
on the side of the lower
handles
9
, adjust the upper handle
3
properly ,then,tighten the quick clamp
5
to secure
the lower handle
9
.
Adjust the handle height
Before installing, make sure the grass box has been properly attached to the metal grass
collection box
7
frame via the clips around the mouth of the box.
Lift the rear discharge door
8
. While holding the door open, place the grass collection box
7
with handle side up into the grooves under the hinge of the rear discharge door
8
, making
sure that the hooks rest properly inside their respective grooves.
After stopping , lift the rear discharge door
8
, take the grass collection box
7
away.
When shipped,the wheels on the mower are set to a low-cutting position.Before using the
Installing the grass collection box
Setting the cutting height
3636
FR
EN
To Next Page
Loading...
