STERWINS PLM1-40Z130.6 - 7.5 Troubleshooting

FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
246
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
7.5 TROUBLESHOOTING
HAZARD ! RISK OF INJURY DUE TO ELECTRIC SHOCK.
BEFORE ANY TROUBLE SHOOTING, SWITCH OFF THE PRODUCT.
Problems Probable cause Solutions Qualification
Excessive noise
The chain is dull /
damaged
Sharpen it or change it
by a new one
CUSTOMER
Nuts / screws are not
well tight
Screw the nut(s) /
screw(s)
CUSTOMER
The blade is not enough
set
Screw the nut(s) /
screw(s)
CUSTOMER
Gasoline leak
There is a leak of gasoline
from to a defective
assemblying (drilled pipe/
bad connection)
Find the leak location
and replace the part by
a new one
AFTER SALES
SERVICE
No engine start
The priming bulb has not
been pressed enough
Press the priming
bulb until the gasoline
is visible inside (4-7
times)
CUSTOMER
The spark plug is dirty
Remove and clean the
electrode with a spark
plug brush (iron bristle
brush)
CUSTOMER
The spark plug spring
doesn't match with the
plug
Remove and change
the spark plug by a
new one
CUSTOMER
The spark plug is
defective
Check is the spring
is still on the cap.
Otherwise change it by
a new one
CUSTOMER
The engine is flooded
Close the starter,
remove the spark plug,
clean the spark plug,
return the machine
and pull the rope 5 to
10 times to empty the
cylinder of gasoline
CUSTOMER
247
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
Problems Probable cause Solutions Qualification
No engine start
The gasoline pipe is
drilled
Remove it and change
it by a new one
AFTER SALES
SERVICE
The carburetor is not well
adjusted
Resume the carburetor
setting procedure from
the beginning
AFTER SALES
SERVICE
The carburetor is
defective
Test it and change it by
a new one
AFTER SALES
SERVICE
The gasoline strainer is
not well placed (on the
bottom)
Check its position or
replace it
CUSTOMER
The starting cable is too
long
Change the cable
AFTER SALES
SERVICE
The switch is on OFF
position
Put the switch on ON
position
CUSTOMER
No engine stop
The OFF switch is
defective
Test it and change it by
a new one
AFTER SALES
SERVICE
The starting cable is too
short
Change the cable
AFTER SALES
SERVICE
The brake system is
defective
Test it and change it by
a new one
AFTER SALES
SERVICE
The trigger system is
defective
Test it and change it by
a new one
AFTER SALES
SERVICE
overconsumption
Carburetor is not well
adjusted /
Resume the carburetor
setti
ng procedure from
the beginning
AFTER SALES
SERVICE
The engine doesn't
go to the idle
speed
Gasoline filter is blocked Replace it by a new one
AFTER SALES
SERVICE
The carburetor idle speed
screw is not well adjusted
Resume the carburetor
setting procedure from
the beginning
AFTER SALES
SERVICE