StetSom SX2 - Page 11

10 11
Using a single TX2 controller to control
mulple devices at the same me:
For the same TX2 control to command various equipment it must be
synchronized with the central RX2 of each one, to so follow the instrucons
in "Synchronizing your Alcance Control" (Page 18). Each car must to have
its central RX2 programmed according to your CD/MP3-Player, to do this,
follow the instrucons showed in the “Programming” (Page 20).
Diagnoscs
• Low baery indicaon:
When you release the Control TX2 buon, the transmission LED indicator
control TX2 transmission (1) and the central LED indicator (16) will remain
lit for 1 second. Replacing the baery with a new one, CR2032 model is
recommended because you may lose control transmission eciency.
The TX2 transmier has a system that is self-o if any key be pressed for
more than 10 seconds to avoid undue baery drain. When you release the
buon, the system works normally.
Replacing the baery of the transmier TX2:
Remove the holster , loosen the two screws on the back , remove the circuit
board from the plasc box, move the discharged removing it from the clip
and put a new baery in place . Observe the baery polarity; the Clip is the
POSITIVE terminal. Mount the control following the steps backwards.
• Loss of synchronizaon:
The loss of synchronizaon occurs when keys are pressed TX2 control over
250 mes out of the reach of central RX2.
Programming
Programming
The central RX2 lets you mix Memory funcons with Learning Mode, it is
possible to carry a device memory by Direct Mode and change some keys
without the other being aected. The process is simple:
1. Follow the steps in the Direct Mode to load into memory the desired
device from the table.
2. Follow the steps in the Learning Mode to program keys/funcons desired.
Note: Whenever using the Learning Mode, the buons/keys that have not
be reassigned will connue execung their original funcons.
1
5
3
2
4
Restoring the Factory Sengs:
Pressing the RESET buon (20) for 5 seconds, the indicator light (16) will
ash and the factory seng are restored. The ming will be maintained.