9
Regulations and standards
The installation (water and electrical
work) and commissioning, as well as the
maintenance of this equipment, must only
be carried out by an authorised qualified
contractor in accordance with these
instructions.
During assembly and installation, observe the
regulations and standards in the heat pump
installation instructions.
WPC 5....13
WPAC 2
WPF 5....13
WPAC 1
C26_03_01_0618C26_03_01_0752
Installation WPAC 1
To protect the equipment against damage, it
must be transported to the installation room
inside its original packaging.
Install the equipment at a suitable point above
the heat pump. Before securing the equipment
to the wall, ensure that the wall is sound
and strong enough to bear the weight of the
equipment.
Mark out the fixing holes with the drilling
template supplied and drill suitable holes.
However, first ensure that the WPF casing has
been lowered.
Connect the equipment with the heat pump
hydraulically using the pressure hoses
supplied. Plastic plug-in connectors are fitted
to the cooling module to make the connection
easy. Plug-in connector fitting on page 10.
Plug the heat pump flow sensor into the
sensor well 6 (see equipment layout).
Dimensions
Dimensions
Pressure-tested
hose
Installation WPAC 2
To protect the equipment against damage, it
must be transported to the installation room
inside its original packaging.
Install the equipment at a suitable point
adjacent to the heat pump. Before securing
the equipment to the wall, ensure that the
wall is sound and strong enough to bear the
weight of the equipment. Mark out and drill
the fixing holes. Plastic plug-in connectors
are fitted to the cooling module to make
the connection easy. Fitting the plug-in
connectors, see page 10.
Plug the heat pump flow sensor into the
sensor well 6 (see equipment layout).
English
To Next Page
Loading...
