11
3.12 Installing casing components
3.12.1 Installing the casing (external installation example
2
1
3
1
5
4
26_03_01_0929
1 Side panel
2 Hood (different for internal / external installation)
3 Front door
4 Type plate
5 Back door
» Place the hood on the appliance and secure with two screws.
» Hook the side panels and front and back doors onto the standard
appliance. Secure these with a screw each.
» Affix the type plate supplied to top front r.h. or l.h. side of the side
panel where it will be clearly visible.
3.12.2 Fitting casing parts for internal installation
Sealing the appliance
Before fitting the casing sections, seal the appliance by affixing a plastic
film; this will prevent condensation forming under all operating condi-
tions.
The plastic film is supplied with the casing sections.
26_03_01_1456
» Apply fabric tape to seal the hole at the bottom of the frame on the
l.h. side. The fabric tape is supplied with the accessory "thermally
insulated air hose".
26_03_01_1454
» Hang the film with the pre-cut holes onto the hooks on the appliance.
26_03_01_1455
» Remove the backing from the adhesive strips on the frame and on the
plastic film.
» Secure the plastic film by pressing it onto the appliance.
» Seal the gaps around the hooks with fabric tape.
Installing casing components
2
1
3
1
5
4
26_03_01_1443
1 Side panel
2 Hood (different for internal / external installation)
3 Front door
4 Type plate
5 Back door
» Place the hood on the appliance and secure with two screws.
» Hook the side panels and front and back doors onto the standard
appliance. Secure these with a screw each.
» Affix the type plate supplied to top front r.h. or l.h. side of the side
panel where it will be clearly visible.
To Next Page
Loading...
