To Next PageTo Next Page
Need help?Do you have a question about the Stiga 85 COMBI and is the answer not in the manual?
General| Brand | Stiga |
|---|---|
| Model | 85 COMBI |
| Category | Lawn Mower Accessories |
| Language | English |
This manual is made up of the cover, table of contents, figures and explanatory text.
Explains warning, mandatory, prohibition, and note symbols used in the manual.
Keep the manual in good, legible condition and accessible to the machine user.
Defines terms like 'main machine' used in the manual.
The accessory is designed specifically to mow lawns.
Any use other than mowing lawns may be dangerous and cause injury or damage.
Signs inform the user about correct conduct and require special caution.
Read instructions carefully, be familiar with controls, learn to stop engine quickly.
Wear sturdy footwear, long trousers, and hearing protection; inspect the area for debris.
Operate in well-ventilated areas, mow in daylight, keep others away, avoid wet grass.
Perform maintenance with engine off, clean the machine, use genuine parts, store safely.
Use ramps for loading, close fuel stopcock, secure machine during transport.
Adhere to local regulations for disposal of waste, oil, fuel, and cuttings.
Perform service on stationary machine, disconnect power, wear gloves, tighten screws.
Adjust cutting height between 25-90 mm using lever or switch.
Adjust rear section of cutting deck assembly to achieve greater forward tilt.
Connect cutting deck assembly to the machine's lift lever using chain and hooks.
Connect cutting deck assembly mounts to machine axles. Includes electric height adjustment, fixed mounts, and quick-release supports.
For best results, cut the top third of the grass; use different heights for long grass.
Adjust rear section for greater forward tilt, affecting cutting results.
Cut grass frequently, use sharp blades, keep bottom clean, do not mow wet grass.
Grass can be composted on the lawn or expelled from the back.
Perform service and checks on a stationary machine with engine off, apply parking brake.
Set tool lift to transport, maximum cutting height, then clean the assembly.
Position machine for maintenance, including removing guards and disconnecting cables.
