Stiga Autoclip M5 User Manual

30
User’s manual
EN
Problem Cause Remedies
The work area is not
completely mowed
Not enough work hours
Extend the working time (see “Programming
Mode”)
Cutting blade clogged with deposits
and/or residuals
Stop the robot safely (see “Robot Safety Stop”)
Warning – Caution
Use protective gloves to prevent injuries to
your hands.
Clean the cutting blade
Cutting blade worn out
Replace the blade with an original spare part
(see “Blade replacement”)
Work area too big compared to the
actual capacity of the robot
Adjust the work area (see “Technical
specications”)
The batteries are about to run out.
Replace the batteries with original spare parts
(see “Battery replacement”)
The batteries do not charge completely
Clean and remove any rust from the contact
points of the batteries (see “Robot Cleaning”).
Secondary area not
completely mowed
Programming error
Correctly program the secondary area (see
“Programming Mode”)
ALERT
Slow orange ashing light
Cutting blade damaged
Replace the blade with a new one (see “Blade
Replacement”).
Cutting blade clogged by residuals
(tape, cords, plastic fragments, etc.).
Safely stop the robot (see “Robot Safety Stop”).
Danger - Attention
Use protective gloves to prevent cutting your
hands.
Unclog the blade.
Grass too high
Increase the cutting height (see “Adjustment of
cutting height”)
The robot is lifted from the ground
Check that the robot is not blocked or obstructed
by any object.
Clean and remove any grass residues from
under the body that may block the sensors.
ALERT
Fast orange ashing light
The perimeter wire is not connected
properly (broken cable, no electrical
connection, etc.)
Check the functioning of the electrical power
supply, the correct connection of the power
supply unit and charging station (see “Installation
of charging station and power supply unit”).
Robot outside the perimeter on a slope
Mark off the area with too much slope (see
“Planning of system installation”)
Robot outside the perimeter
Check that the wire has been installed correctly
(too deep, next to metallic objects, distance
between the wire marking the two elements
less than 70 cm, etc.) (see “Planning of system
installation”)
Robot inside a ower bed
Reposition the perimeter wire correctly (counter-
clockwise direction) (see “Installation of
perimeter wire”).

Stiga Autoclip M5 Specifications

General

Brand	Stiga
Model	Autoclip M5
Category	Lawn Mower
Language	English