What to do if my Stiga EXPERIENCE e-Ride C500 Lawn Mower has unusual vibrations?
If you notice unusual vibrations while using your Stiga Lawn Mower, it could be due to incorrectly balanced or loose cutting blades, loose parts, or possible damage. It is recommended to contact an authorized service center for verification, replacements, or repairs.
What does it mean if the icons in fig. 13.E and fig. 13.O remain ON, battery LEDs 2, and 4 fal sh on my Stiga EXPERIENCE e-Ride C500?
This indicates the battery is experiencing over or under temperature issues, possibly due to unsuitable environmental or demanding work conditions. Turn off the machine, wait for at least 5 minutes, and then restart it. Also, ensure you are working in an environment with a temperature appropriate for the machine's operating conditions. Reduce forward speed and increase the cutting height.
Why is my Stiga Lawn Mower not switching on?
The machine may not switch on due to a low battery. Charge the battery.
What does it mean if the icons in fig. 13.E and fig. 13.O remain ON, battery LEDs 1 and 3 flash on my Stiga EXPERIENCE e-Ride C500 Lawn Mower?
This indicates the cutting blades motor is overheating, possibly due to demanding work conditions. Turn off the machine, wait for at least 5 minutes, and then restart it. Reduce forward speed and increase the cutting height.
What does it mean if the icons in fig. 13.E and fig. 13.O remain ON, battery LEDs 1, 2 and 4 flash on my Stiga EXPERIENCE e-Ride C500?
This indicates the drive motor is overheating, possibly due to the drive motor being under stress, a steep slope, or excessive mud on the wheels. Switch off the machine and wait for at least 5 minutes before repeating the starting procedure. Reduce forward speed. Reduce speed and check the slope of the ground where you are working. Ensure the wheels are not blocked and clean them as needed.
What does it mean if the icons in fig. 13.E and fig. 13.O remain ON, battery LEDs 1, 2, 3 and 5 flash on my Stiga EXPERIENCE e-Ride C500 Lawn Mower?
This indicates the drive engagement/disengagement lever is in the drive disengaged position. Check the position of the drive engagement/disengagement lever and, if necessary, return it to the drive engaged position.
What to do if [Push-button panel Type I] The icon fig. 12.E stays on and the battery LEDs 1 and 3 flash [Push-button panel Type II] The icons fig. 12.E and fig. 12.N stay on and the battery LEDs 1 and 3 flash on my Stiga EXPERIENCE e-Ride C500?
If the icon fig. 12.E stays on and the battery LEDs 1 and 3 flash (or icons fig. 12.E and fig. 12.N stay on and the battery LEDs 1 and 3 flash), it indicates the cutting means motors are overheating due to heavy working conditions. Turn the machine off, wait at least 5 minutes, and then restart it. You can also reduce the travel speed or increase the cutting height.
What to do if [Push-button panel Type I] The icon fig. 12.E stays on and the battery LEDs 1 , 2, 4 and 5 flash [Push-button panel Type II] The icons fig. 12.E and fig. 12.O stay on and the battery LEDs 1, 2, 4 and 5 flash on my Stiga Lawn Mower?
If the icon fig. 12.E stays on and the battery LEDs 1, 2, 4 and 5 flash (or icons fig. 12.E and fig. 12.O stay on and the battery LEDs 1, 2, 4 and 5 flash), it means the machine was started with the drive pedal not released (not in neutral position). Turn the machine off and repeat the starting procedure only after making sure that the drive pedal is in neutral (pedal released).
What to do if [Push-button panel Type I] The icon fig. 12.E stays on and the battery LEDs 1 , 2 and 4 flash [Push-button panel Type II] The icons fig. 12.E and fig. 12.N stay on and the battery LEDs 1, 2 and 4 flash on my Stiga Lawn Mower?
If the icon fig. 12.E stays on and the battery LEDs 1, 2 and 4 flash (or icons fig. 12.E and fig. 12.N stay on and the battery LEDs 1, 2 and 4 flash), it indicates overheating of the drive motor. This can be due to the drive motor being under strain, a slope that is too steep, or excessive mud on the wheels. Reduce the travel speed, check the gradient of the slope, and ensure the wheels are not blocked and clean them if necessary.
What does it mean if icon fig. 12.E stays on and the battery LEDs 2 and 5 flash on my Stiga Lawn Mower?
If the icon fig. 12.E stays on and the battery LEDs 2 and 5 flash, it indicates a current overload from the battery. This could be due to excessive working conditions or a slope that is too steep. Reduce the travel speed and check the gradient of the terrain you are working on.
General| Power Source | Battery |
|---|---|
| Battery Type | Lithium-ion |
| Battery Voltage | 48 V |
| Battery Capacity | 40 Ah |
| Motor | Brushless |
| Cutting Width | 84 cm |
| Cutting Height Adjustment | 7 Positions |
| Cutting Height Adjustment Type | Manual |
| Drive | Rear-wheel drive |
| Collector Capacity | 240 L |
| Cutting Height | 25-80 mm |
| Run Time | 60 minutes |
| Charging Time | 8 hours |
To Next Page