EN - 12
•
•
•
•
7.2.2
recharging
NOTE The battery is equipped with a guard
that inhibits recharging if the environmental
temperature is not between 0 and +45 °C.
NOTE The battery can be recharged at any
time, even partially, with no risk of damaging it.
7.3 CLEANING THE MACHINE
AND THE MOTOR
•
•
• Do not use aggressive detergents or solvents
to clean the plastic parts or hand grips.
•
•
cooling air vents clean and free of debris.
•
7.4 NUTS AND BOLTS
•
•
7.5 CUTTING HEAD
Do not touch the cutting head until
the battery has been removed and the
cutting head is completely stationary.
IMPORTANT Cutting head displaying
the code indicated on the Technical Data
table should be used on this machine.
Given product evolution, the cutting head
7.5.1
cutting line head
1.
2.
3.
4.
7.5.2 Replacing the cutting line head
1.
2.
3.
4.
5.
6.
7.
7.6 SHARPENING THE LINE
CUTTING KNIFE
1.
2.
to retain the original cutting angle.
3.
.
To Next Page
Loading...
Need help?
General
