64
ENGLISH
EN
5.12 Lubrication
All lubrication points in accordance with the table
below must be lubricated every 50 hours of opera-
tion as well as after every wash.
5.13 Fuses
If any of the faults listed below occurs, replace the
relevant fuse. See fig. 13.
6 PATENT - DESIGN REGISTRA-
TION
This machine or parts thereof is covered by the fol-
lowing patent and design registration:
SE9901091-0, SE9901730-3, SE9401745-6,
US595 7497, FR772384, DE69520215.4,
GB772384, SE0301072-5, SE04/000239 (PCT),
SE0401554-1, SE0501599-5.
GGP reserves the right to make alterations to the
product without prior notification.
Object Action Fig-
ure
Wheel bear-
ing
2 grease nipples.
Use a grease gun filled with
universal grease. Pump until
the grease emerges.
23
Centre point 4 grease nipples.
Use a grease gun filled with
universal grease. Pump until
the grease emerges.
24
Steering
chains
Brush the chains clean with a
wire brush.
Lubricate with universal
chain spray.
-
Tensioning
arms
Lubricate the bearing points
with an oil can when each
control is activated.
Ideally carried out by two
people.
25
Control
cables
Lubricate the cable ends with
an oil can when each control
is activated.
Must be carried out by two
people.
26
Fault Fuse
The engine does not start or starts and
stops immediately. The battery is
charged.
10 A
Electrical cutting height adjustment
do not work.
20 A
All electrical functions are out of
operation. The battery is charged.
30 A
To Previous Page
Loading...
Need help?
General
