Stiga SBK 45 D - Troubleshooting; Technical Specifications

TROUBLESHOOTING / TECHNICAL SPECIFICATIONS 15
EN
9. TROUBLESHOOTING
1) The engine will
not start or will not
keep running
2) The engine starts
but is lacking in
power
3) The engine runs
irregularly and lacks
in power when
revved
4) The engine gives
off an excessive
amount of smoke
– Incorrect starting procedure
– Dirty spark plug or incorrect distance
between the electrodes
– Air filter clogged
– Carburetion problems
– Air filter clogged
– Carburetion problems
– Dirty spark plug or incorrect distance
between the electrodes
– Carburetion problems
– Incorrect composition of the fuel
mixture
– Carburetion problems
– Follow the instructions
(see chapter 6)
– Check the spark plug
(see chapter 8)
– Clean and/or replace the filter
(see chapter 8)
– Contact your dealer
– Clean and/or replace the filter
(see chapter 8)
– Contact your dealer
– Check the spark plug
(see chapter 8)
– Contact your dealer
– Prepare the fuel mixture according
to the instructions (see chap. 5)
– Contact your dealer
PROBLEM LIKELY CAUSE SOLUTION
10. TECHNICAL SPECIFICATIONS
Spark plug: NGK BPMR8Y
Mixture: Petrol : 2-stroke oil = 50:1 = 2%
Maximum permitted blade diameter: 3 or 4 point blade = Ø 255 mm
Saw blade = = Ø 255 mm
1)
Weight as per standard ISO 11806-1 (without fuel, cutting devices and harness)
MODEL
Engine 2-stroke air-cooled
BKE 45D BKE 45F BKE 53D BKE 53F
Weight
1)
kg 8.7 12.7 9.4 13.3
Capacity / Power
cm
3
/kW
45.4/1.42 45.4/1.42 53.2/2.0 53.2/2.0
Rotation speed at tick-over min
-1
3000 3000 3000 3000
Maximum engine rotation speed min
-1
10800 10800 9500 9500
Maximum tool rotation speed min
-1
6900 6900 6900 6100
Tank capacity
cm
3
900 900 1100 1100