EN - 22
• Type “II”
1.
2. Place a suitable container under
3.
using a pair of pliers, loosen the
4. Bend the extension tube and
drain the oil into the container.
5.
and reattach the extension tube
6.
• Type “III”
1.
2. Place a suitable container under
3.
4.
5. Bend the extension tube and drain
the oil into a suitable container.
6.
before topping up the oil.
7.
Hand the spent
oil over to a disposal facility in
accordance with local provisions.
7.4
AND CUTTING device DISENGAGED.
1.
2.
in the desired position
3.
7.5
•
•
•
must be recharged as soon as possible.
Recharging must be
done using a battery charger at constant
voltage. Other recharging systems can
irreversibly damage the battery.
•
the corresponding connector for the special
This connector must
only be used for connection to the
maintenance battery charger indicated
by the Manufacturer. For its use:
– follow the instructions given in the
relative instruction manual;
– follow the instructions in the battery manual;
7.6 CLEANING
7.6.1 Cleaning the machine
•
electrical parts or the electronic circuit
board located under the dashboard.
•
and petrol storage area free of grass,
leaves, or excessive grease.
To Next Page
Loading...
