EN - 24
8.2.2
All work on the cutting device
(disassembly, sharpening, balancing,
repairing, reassembly and/or replacing)
are demanding jobs that require special
skills as well as special tools. For safety
reasons, these jobs are best carried
out at a Authorised Service Centre.
Always replace damaged, bent
or worn cutting device, together
with their nuts and bolts, in order to
ensure they remain balanced.
We strongly recommend
changing all the cutting device at the same
time, especially in the case of uneven wear.
Always use original
cutting device bearing the code
indicated in the “Technical Data”.
Given product evolution, the cutting device
8.3
8.3.1 Preparation
Use a suitable lifting
device, for example a scissor jack.
•
•
and even surface that guarantees
•
•
•
•
•
perpendicular to the ground.
8.3.2 Choice and positioning of the
•
•
•
•
NOTE In this position the jack allows you
to only raise the wheel to be changed.
8.3.3 Choice and positioning of the
1.
2.
NOTE Select the position of the jack
depending on the type of machine.
3.
NOTE The jack must be positioned under
the at part of the support (g. 44.B, 45.B).
NOTE The jack must be positioned under
the central rib of the support (g. 46.B).
8.3.4 Changing the wheel
Make certain the machine
remains still and stable during the lifting process.
If you notice anything out of the ordinary,
lower the jack immediately, check and resolve
any problems and lift the machine again.
1.
2.
3.
4.
5.
lubricating grease.
6.
7.
8.
To Next Page
Loading...
Need help?
General
