EN - 12
5.10 ENABLE REVERSE GEAR
CUTTING BUTTON
causing the engine to stop.
5.11 CONTROLS FOR ADJUSTING THE
CUTTING UNIT ASSEMBLY HEIGHT
• Control with lever
The seven positions for this lever,
correspond to various cutting
To change positions,
press the release button
on the end of the lever.
• Control with lever and knob
• Position «A»
• Position «B»
1.
2. Adjust the cutting height using
3.
NOTE Set the lever (g. 15.H) to position
«A» during transport and shipping.
5.12 SPEED CRUISE CONTROL
1. Pressed. Device disabled
(deactivated)
2. Pulled out. Device
enabled (active)
•
• The device cannot be used
•
NOTE Speeds may vary with respect
to the selected value when the machine
is moving up or down slopes.
To deactivate the device and restore pedal
•
or
•
IMPORTANT Never use the mushroom
button to deactivate the device.
5.13
and indicates the engine operating hours.
To Next Page
Loading...
Need help?
General
