)Y/
0
0
0
0
o
t\U
Top: Fitting saw chain
on guide bar
Center Fitting the chain on the sprocket cutting edges
point
toward
bar nose
Bottom
Peg of
tensioner
slide/tensioning nut in locating hole
guide
bar
flat against
saw body
Pretensioning the chain
(lateral
chain
tensioner)
Hold the
guide
bar vertically with the nose
upward and fit
the Oilomatic chain
on
it, starting
at
the bar
nose.
With the
chain in
position, locate the slot of the guide bar
over the
studs (7) and place the Oilomatic chain
over
the
sprocket (8) at the same time. Be sure that the
cutting
edges
on
the
top
of the bar point
toward
the
bar nose. The
peg of the
tensioner slide/tensioning
nut
(6)
must
engage
the lower guide bar locating hole.
Now tension the chain
by turning the adjusting screw (4)
or tensioning
screw (5) clockwise until there is very little
chain
sag on
the underside of the bar. Make
sure
that the
drive link
tangs
(9)
are
properly located in
the guide bar
groove.
Fit the
sprocket cover (3) on the studs (7) and screw
on the
hexagon
nuts
(2) finger-tight.
27
To Next Page
Loading...
