•
Pull the hand guard back toward
the front handle:
the chain brake is now
disengaged -
your saw is ready for operation.
•
Observe safety precautions.
•
Always check operation of chain
lubrication before starting work.
6KXWGRZQHQJLQH
•
Move Master Control lever to
"Stop" E
Always disengage the chain brake
before opening the throttle. Running the
engine at higher revs with the chain
brake engaged (saw chain at a
standstill) will quickly damage the engine
and chain drive (clutch, chain brake).
$WYHU\ORZRXWVLGHWHPSHUDWXUHV
$OORZHQJLQHWRZDUPXS
As soon as the engine runs:
•
Blip the throttle trigger
to disengage it from starting throttle
position -
Master Control lever will move
to normal operating position -
engine settles down to idling speed.
•
Disengage chain brake:
Pull hand guard toward front handle
as shown in illustration -
•
Open throttle slightly -
warm up engine for short period.
•
Change over to winter operation
if necessary -
see section "Winter Operation".
,IHQJLQHGRHVQ¶WVWDUW
If you did not move the Master Control
lever to "Warm Start" Q
quickly enough after the engine began
to fire, the combustion chamber has
flooded.
•
Turn knob or lever above rear
handle 90° counterclockwise.
•
Lift off the carburetor box cover
vertically.
143BA012 KN
143BA012 KN
133BA009 KN
133BA010 KN
To Next Page
Loading...
