Stihl 26 - Replacing Starter Rope and Rewind Spring

5HSODFLQJ6WDUWHU5RSH
•
Take out the screws .
•
Remove four screws -
•
Push the hand guard upward -
•
Pull underside of fan housing away
from crankcase and remove it
downward
•
Ease the spring clip  off the
starter post.
•
Carefully slip the washer  and
pawl  off the starter post.
:DUQLQJ
Take particular care to avoid injury - the
rewind spring may pop out and unwind.
•
Ease the cap out of the starter
grip.
•
Remove remaining rope from the
rotor and grip. Make sure the
sleeve does not slip out of the grip.
•
Tie a simple overhand knot in the
end of the new starter rope -
1113 195 8200 (Ø 3,5x960) -
and then thread the rope through
the top of the grip and the rope
bush .
•
Refit the cap in the grip.
•
Pull the rope through the rotor and
secure it with a simple overhand
knot.
6DZVZLWKRXW(ODVWRVWDUW
•
Thread the new rope -
3.5 mm (
9
/64") dia. and 960 mm
37
3
/4") long - through the rotor and
secure it with a simple overhand
knot.
•
Thread the other end of the rope
through the guide bush (from
inside) and the underside of the
starter grip and secure it with a
special knot - do not wind rope onto
rotor.
2
3
4
133BA015 KN
133BA040 KN
6
5
1
1
1
1
133BA014 KN
5HSODFLQJ6WDUWHU5RSH
DQG5HZLQG6SULQJ
135BA032 L
Ä
 