; If the engine is being assembled and the flywheel is not in place yet, just be sure the
piston is at top dead center to time the cam correctly.
;
To install the cam on the backpack blower engines, notice that when the piston is at
top dead center, the cam lobe is pointing up when the alignment marks are
matched up. Now install the dowel pin.
Rotate the crankshaft until the tip (arrow) of the
flywheel lines up with the ignition module as
shown.
Fit the cam gear so that the arrows (2) and (3) are
in alignment with the notches (1and 4) in the
cylinder.
To Previous Page
Loading...
