Page 16 Technical Information 08.2005
TI_08_2005_11_01_02.fm
5.4.5 Set valve clearance
. Insert setting gauge (1) between rocker arm and
valve stem
Depending on the momentary valve clearance:
. Turn nut (2) clockwise to reduce the valve
clearance or anticlockwise to increase it – the
setting gauge must produce a slight suction
effect when it is pulled through
. Rotate the crankshaft twice until the tip of the
flywheel is flush with the ignition coil.
. Check the valve clearance again and re-adjust if
necessary
5.4.6 Assembly
Use the gaskets in kit 4282 007 1001 "Parts for
adjusting valve clearance".
. Fit gasket (1) in position (arrows)
. Fit valve cover and tighten screw with a torque
of 6 Nm
. Mount the air guide shroud
. Screw in spark plug, fit shroud, and plug in spark
plug boot
. Fit starter cover and tighten down screws
. Start engine and let it warm up
. Switch off engine
. Check engine does not leak
To Next Page
Loading...
