What to do if my Stihl BR 800 Blower engine does not start?
If your Stihl Blower engine does not start, and an MDG 1 analyzer is available, create a diagnostic report and test the blower with it. If not, try replacing the carburetor. Also, if the fuel system is leaking, replace the fuel hoses. Clean the cable lugs on the wiring harness and the screws on the cylinder. Note that if the spark plug is damp, you should consult section 4.
Why is my Stihl BR 800 engine not delivering full power?
If your Stihl Blower engine does not deliver full power or runs erratically, create a diagnostic report and test the blower with an MDG 1 analyzer if available. Otherwise, clean the old air filter properly or fit a new filter. Also, replace the pickup body in the fuel tank. If the fuel system is leaking, replace the fuel hoses.
How to fix no spark on a Stihl BR 800 Blower?
If your Stihl Blower has no spark, create a diagnostic report and test the blower with an MDG 1 analyzer if available. If the spark plug is sooted or smeared with oil, clean or replace it. Install a new ignition module and replace the flywheel if it is damaged. Also, ensure the air gap between the ignition module and flywheel is correctly set.
Why does my Stihl BR 800 Blower engine run erratically?
If your Stihl Blower engine does not run or runs erratically, with misfiring and sporadic loss of power, you can create a diagnostic report and test the blower with an MDG 1 analyzer if available. Otherwise, try installing a correct spark plug. If the spark plug is sooted or smeared with oil, clean or replace it. Ensure the spark plug electrode gap is correctly set. If the spark plug boot is damaged, replace it. Also, push the connector of the wiring harness’ black wire firmly into place. If the black wire of the wiring harness is chafed, replace the throttle cable with wiring harness. Consider replacing the ignition lead or the flywheel if damaged. Finally, check the decompression system; if damaged, install a new cam gear.
Why does my Stihl BR 800 engine stop when I release the throttle?
If the Stihl Blower engine stops when the throttle trigger is released, create a diagnostic report and test the blower with the MDG 1 analyzer if available. Otherwise, clean the old air filter properly or fit a new filter. Also, adjust the throttle shutter correctly and fit a new tank vent. If the fuel system is leaking, replace the fuel hoses.
Why does the starter rope on my Stihl BR 800 not rewind?
If the starter rope on your Stihl Blower does not rewind, the rewind spring may be broken, very dirty, rusted, or improperly tensioned. Replace the rewind spring if broken or clean/replace it if dirty or rusted. If the rewind spring is properly tensioned, replace the rewind starter. You may also need to increase the tension of the rewind spring.
Why does my Stihl BR 800 Blower engine stop suddenly?
If your Stihl Blower engine stops suddenly, create a diagnostic report and test the blower with an MDG 1 analyzer if available. Otherwise, replace the pickup body in the fuel tank and replace the fuel hoses.
Why is the starter rope on my Stihl BR 800 hard to pull?
If the starter rope on your Stihl Blower is difficult to pull or rewinds very slowly, it could be due to the windings of the rewind spring sticking together. To resolve this, coat the rewind spring with a standard solvent-based degreasant containing no chlorinated or halogenated hydrocarbons, and then pull the starter rope several times until normal action is restored.
Why does my Stihl Blower stall at idle but runs at full throttle?
If your Stihl Blower engine does not start easily, stalls at idle speed, but operates normally at full throttle, create a diagnostic report and test the blower with an MDG 1 analyzer if available. Otherwise, replace the oil seals or seal up or replace the crankcase.
Why can't I pull the starter rope out far enough on my Stihl Blower?
If the starter rope on your Stihl Blower cannot be pulled out far enough, it is because the tension of the rewind spring is too high. Reduce the tension of the rewind spring.
Requirements and considerations for the person using the blower.
Details health requirements for safe operation, avoiding fatigue and impairment.
Specifies appropriate attire and footwear for safe operation.
Covers safe handling and operation procedures, including static discharge.
Critical steps for safe refueling to prevent fire and injury.
Safe procedures for starting the engine in various conditions.
Procedure for safely opening the fuel cap to relieve pressure.
Advice for safe operation in various environments and terrains.
Step-by-step guide to connecting hose components securely.
Safe procedure for opening the fuel tank to relieve pressure.
Instructions for adding fuel to the tank, avoiding overfilling.
Safe procedure for closing the fuel tank after refueling.
Procedures for starting the engine in cold and warm conditions.
Starting method for Easy2Start models.
Starting method for non-Easy2Start models.
Troubleshooting steps for engine starting issues.
Procedures for safely stopping the engine.
Guidelines for safe and efficient operation of the blower.
Explains user's rights and responsibilities regarding emissions warranty.
General| Type | Backpack blower |
|---|---|
| Airflow | 2025 m³/h |
| Suction mode | - |
| Product color | Black, Orange, White |
| Airspeed (max) | 349.2 km/h |
| Power source | Gasoline |
| Sound power level | 112 dB |
| Sound pressure level | 104 dB |
Weight and Dimensions| Weight | 11700 g |
|---|
To Next Page
