Stihl 44

Pull the prefilter (1) upward and out -
Pull off the spark plug boot (2) -
•
••
•
Unscrew and dry off the spark plug -
•
••
•
Set the Master Control lever to b
•
••
•
Crank the engine several times
with the starter to clear the
combustion chamber -
•
••
•
Refit the spark plug and
connect the spark plug terminal -
reassemble all other parts.
•
••
•
Set Master Control lever
to “Warm Start” n
even if engine is cold.
•
••
•
Now start the engine.
Fuel tank run until dry and then
refueled
•
••
•
Pull starter rope several times until
fuel line is primed.
Different quantities of oil are required for
different bar lengths, types of wood and
cutting techniques.
Use the adjusting screw (1) to vary the
oil feed rate as required.
•
••
•
Most economic setting -
turn adjusting screw to "E"
(Ematic position).
•
••
•
To increase oil feed -
turn adjusting screw clockwise.
•
••
•
To reduce oil feed -
turn adjusting screw counter-
clockwise.
Your chain must always be wetted with
a film of lubricant.
1
139BA001 KN
2
132BA001KN
Oil Quantity
Control
1
145BA011 K
044 33