•
••
•
Remove the screws (1) -
•
••
•
Push the hand guard upward -
•
••
•
Pull underside of fan housing away
from crankcase and remove it
downward.
Use screwdriver or suitable pliers
to carefully remove spring clip (2)
from the starter post.
•
••
•
Remove the rope rotor
with washer (3) and pawls (4)
•
••
•
Use a screwdriver to pry the rope
out of the starter grip
•
••
•
Remove remaining rope from the
rotor and starter grip
•
••
•
Thread the new rope through the
top of the starter grip and then pull
through the rope guide bush (5).
•
••
•
Thread the rope through the rotor
and secure it with a simple
overhand knot.
•
••
•
Coat rope rotor bearing bore with
non-resinous oil.
•
••
•
Slide rotor onto starter post -
turn it back and forth so that anchor
loop of rewind spring engages -
•
••
•
Refit the pawls (4) in the rotor -
•
••
•
Fit the washer (3) on the starter post
•
••
•
Use screwdriver or suitable pliers
to install spring clip (2) on starter
post and over the pawl pegs -
the spring clip must point in
clockwise direction -
see illustration.
Tensioning rewind spring
•
••
•
Make a loop in the unwound starter
rope and use it to turn the rope rotor
six full revolutions clockwise.
•
••
•
Hold the rotor steady -
Straighten the twisted rope -
133BA016 KN
5
4
4
3
2
001BA096 KN
Replacing Starter Rope
and Rewind Spring
1
1
1
1
133BA014 KN
4
4
3
2
001BA096 KN
044 41
To Next Page
Loading...
