•
Pull the rope through the rotor and
secure it with a simple overhand
knot.
•
Lubricate rope rotor bore with
non-resinous oil.
•
Push rotor onto the starter post -
turn back and forth until loop of
rewind spring engages.
•
Insert screw and tighten down
securely.
7HQVLRQLQJUHZLQGVSULQJ
•
Make a loop in the starter rope
and use it to turn the rope rotor
six full revolutions counter-
clockwise.
Hold the rotor steady -
straighten the twisted rope -
release the rotor -
let go of rope slowly so that it
winds onto the rotor.
The starter grip must be firmly
seated in the rope guide bush.
If grip droops to one side:
Add one more turn on rope rotor
to increase spring tension.
326BA028 KN
355B
A020
355BA021 KN
%*
To Next Page
Loading...
