Stihl BGA 85 - Page 15

BGA 85
English
13
During Operation
The green light emitting diodes glow
continuously or flash to indicate the state
of charge.
If the light emitting diodes on the battery
flash or glow red – see "If the red light
emitting diodes glow continuously /
flash".
If the red light emitting diodes glow
continuously / flash
3901BA016 KN
80 - 100 %
60 - 80 %
40 - 60 %
20 - 40 %
0 - 20 %
A 1 light emitting
diode glows
continuously
red:
Battery is too
hot
1) 2)
/cold
1)
1)
When charging: Charge process
starts automatically after the battery
has cooled down / warmed up.
B 4 light emitting
diodes flash red
Malfunction in
battery
3)
C 3 light emitting
diodes glow
continuously
red:
Power tool is too
hot – allow it to
cool down.
D 3 light emitting
diodes flash red
Malfunction in
power tool
4)
3901BA041 KN
A
B
C
D
2)
During operation: Power tool cuts
out – allow battery to cool down; it
may be necessary to take the
battery out of the power tool for this
purpose.
3)
Electromagnetic interference or
malfunction. Take the battery out of
the power tool and refit it. Switch on
the machine – if the LEDs continue
to flash, the battery has a
malfunction and must be replaced.
4)
Electromagnetic interference or
malfunction. Take the battery out of
the machine. Use a blunt tool to
remove dirt from the contacts in the
battery compartment. Refit the
battery. Switch on the power tool –
if the light emitting diodes still flash,
the power tool is malfunctioning
and must be checked by a servicing
dealer – STIHL recommends an
authorized STIHL servicing dealer.