What does it mean if 4 LEDs flash red on my Stihl Blower?
If 4 LEDs flash red on your Stihl Blower (and a rapid succession of short beeps is emitted on STIHL AR Series blowers), it indicates a malfunction in the battery. Remove and reinsert the connecting cord, then switch on the blower. If the LEDs continue to flash, do not attempt to use the blower, as the battery needs replacement.
How to fix a Stihl BGA 200 Blower that does not start?
If your Stihl Blower does not start when switched on, it could be due to no electrical contact between the blower and the battery. Remove the battery and visually check the electrical contacts in the socket. Reinsert the connecting cord. If it still doesn't start, clean the contact surfaces on the connecting cord.
Why does my Stihl BGA 200 cut out during operation?
Your Stihl blower might cut out during operation if the battery is either too hot or too cold. To resolve this, remove the connecting cord and allow both the blower and the battery to gradually cool down or warm up at ambient temperatures of about 50 °F to 68 °F (10 °C to 20 °C).
What to do if my Stihl BGA 200 does not start when switched on?
If your Stihl blower doesn't start, it could be due to a lack of electrical contact between the blower and the battery. Here's what you can do: * Remove the battery and visually inspect the electrical contacts in the socket. * Reinsert the connecting cord. * If it still doesn't start, clean the contact surfaces on the connecting cord.
Why does my Stihl BGA 200 turn off while in operation?
Your Stihl blower might be turning off during operation due to a couple of reasons. The blower could be overheating; in this case, pull the connecting cable plug out of the socket and allow the blower to cool down. Alternatively, there might be an electrical fault. Try pulling the connecting cable plug out of the socket and plugging it back in again.
Why Stihl BGA 200 runtime is too short?
A short runtime for your Stihl Blower can be due to a battery that is not fully charged. Recharge the battery fully as described in the instruction manual for the STIHL AL 101, 300, 500 chargers. Alternatively, the battery may have reached the end of its normal life and needs to be replaced.
Why Stihl BGA 200 Blower does not start when switched on?
Several factors can prevent your Stihl Blower from starting. It could be due to a low battery charge, which requires a full recharge as detailed in the STIHL AL 101, 300, 500 chargers instruction manual. The battery might be too hot or too cold; in this case, disconnect the cable and allow the battery to reach a moderate temperature. There might be a blower malfunction; try disconnecting and reconnecting the cable, then switch the blower on. If 3 LEDs flash red, stop using the blower and seek assistance from your STIHL servicing dealer. A battery malfunction could also be the reason; disconnect and reconnect the cable, and if 4 LEDs flash red, discontinue use and contact your STIHL dealer. Poor electrical contact between the blower and battery can also cause this; try disconnecting and rec...
What to do if my Stihl Blower does not start?
If your Stihl Blower doesn't start, several factors could be at play. First, the battery charge might be too low, so charge the battery. Second, the battery could be too warm or cold; in that case, pull the connecting cable plug out of the socket and allow the battery to cool down or warm up. Third, the blower itself might be too warm; pull the connecting cable plug and let it cool. There may be no electrical contact between the blower and the battery; in that case, pull the connecting cable plug out of the socket and plug it in again. If the blower still doesn’t start, clean the contacts of the connecting cable. The blower or battery might be damp, so allow them to dry. Finally, ensure you're not pressing the trigger before operating the release slide; turn on the blower as described in t...
What to do if Stihl Blower battery is too hot or too cold?
If the battery of your Stihl Blower is too hot or too cold, allow it to warm up or cool down gradually at ambient temperatures of about 50 °F to 68 °F (10 °C to 20 °C).
Why is the run-time so short on my Stihl BGA 200 Blower?
If your Stihl Blower's run-time is too short, it could be due to the battery not being fully charged. In this case, charge the battery as described in its instruction manual. Alternatively, the battery's useful life may have been reached or exceeded, and you should have the battery checked by an authorized STIHL servicing dealer.
Identifies and explains safety symbols specifically found on the blower unit.
Lists checks and preparations required before starting the blower operation.
Explains proper grip, footing, and balance techniques for safe blower control.
Provides detailed steps for safe operation, including fan safety and handling thrown objects.
Safety precautions and warnings related to the handling and use of batteries.
General safety guidelines applicable to all battery-powered products.
Steps to prepare the blower and battery before starting work.
Instructions for charging the battery using the STIHL charger.
Instructions for adjusting and using the STIHL AR L backpack battery harness.
Guides on how to properly route and secure the connecting cord for safety.
Step-by-step guide on how to safely turn the blower on.
Step-by-step guide on how to safely turn the blower off.
Guidelines for the correct usage of the blower during operation, including directing airflow.
Detailed steps for inspecting and maintaining the blower's components.
A guide to identify and resolve common problems encountered with the blower.
General| Type | Handheld blower |
|---|---|
| Power | - W |
| Airspeed | - km/h |
| Working type | Blowing |
| Product color | Black, Orange, White |
| Working technology | Electric |
| Secondary handle | Yes |
| Battery voltage | 36 V |
Weight and Dimensions| Weight | 3200 g |
|---|
To Next Page
