Stihl BR 200 - Assembling the Unit; Fitting the pleated hose on the elbow; Mounting the blower tube and nozzle; Mounting the control handle

BR 200
English
10
A screwdriver is included in the
accessory bag provided.
Fitting the pleated hose on the elbow
N Open the hose clamp (1) and fit it on
the pleated hose (2).
N Engage the tab in the recess.
N Push the pleated hose (2) over the
slip ring (3) as far as stop.
N Line up the hose clamp (1) and slip
ring (3) – as shown.
N Tighten down the screw (arrow).
Mounting the blower tube and nozzle
N Connect the blower tube (4) and
nozzle (5).
Mounting the control handle
N Pull the ends of the clamp on the
control handle (6) apart and push it
over stub of pleated hose (2).
N Attach throttle cable to retainer on
the hose clamp (1).
Adjusting the control handle
N Put the machine on your back and
adjust the harness – see "Fitting the
Harness".
N Push the blower tube (4) into the
stub of pleated hose (2) as far as
the stop.
N Move the control handle (6) along
the tube to the most comfortable
position.
N Tighten down the screw in the
control handle (6).
Assembling the Unit
1
2
9928BA001 AM
3
1
2
9928BA002 AM
9928BA019 AM
4 5
9928BA003 AM
1
6
2
9928BA004 AM
2 4
6
9928BA005 AM