BR 200
English
14
Starting the Engine
N Observe safety precautions.
N Move the setting lever the run
position F.
N Press the manual fuel pump bulb at
least five times – even if the bulb is
filled with fuel.
Cold engine (cold start)
N Turn the choke knob to g.
Warm engine (warm start)
N Turn the choke knob to <.
Also use this setting if the engine has
been running but is still cold.
Starting
N Place the unit securely on the
ground and make sure that
bystanders are well clear of the
nozzle outlet.
N Make sure you have a firm footing:
Hold the unit with your left hand on
the carrying handle and put one foot
against the base plate to prevent it
slipping.
N Pull the starter grip slowly with your
right hand until you feel it engage
and then give it a brisk strong pull.
Do not pull out the starter rope to full
length – it might otherwise break.
N Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
N Continue cranking until the engine
runs.
Starting / Stopping the
Engine
Start your unit on a clean, dust-
free surface only to ensure that no
dust is sucked in.
9928BA006 AM
9928BA008 AM
9928BA015 AM
To Next Page
Loading...
