23
9
After SW update, go to Design Menu by
Pressing MENU => AUDIO MENU => 8 5 3 2
10
Go to Setup design menu and Select Clear
EEPROM option and press OK key of remote.
11
After Clear EEPROM, the set will go to stand
by and will again restart automatically in RF
source.
12
Then verify the modelwise Audio/ Video
settings as per Design data (in PLM). Verify
the SW date and version in Version info in
Design data
13
Then press Shipping in Setup design menu by
pressing OK key of remote, after shipping set
then
Switch OFF the set from main power and
again Switch ON. The SW loading process Is
complete.
STEPS TO FOLLOW AFTER SW INSTALLATION: -
To Next Page
Loading...