Stihl FS 310 User Manual

FS 310
English
22
Guard ring for mowing applications
For optimum protection from the ingress
of grass when using grass cutting
blades and brush knives
N Mount the guard ring (1) for mowing
applications.
N Fit the thrust plate (2) and the guard
washer (3).
Guard ring for sawing applications
For circular saw blades
N Fit the guard ring (1) for sawing
applications.
N Fit the thrust plate (2).
Cleaning the Gearbox and Cutting
Attachment Mounting Hardware
Clean the gearbox, the area surrounding
it, inside the grass shield and the cutting
attachment mounting hardware at
regular intervals. Also check for
contamination when changing the
cutting attachment and clean thoroughly
if necessary.
N Remove all cutting attachment
mounting hardware from the
gearbox for this purpose.
Block the shaft.
N Insert the stop pin (1) in the bore (2)
in the gearbox as far as stop, apply
slight pressure.
N Rotate the shaft until the stop pin
slips into position.
Mount the cutting attachment.
WARNING
Use a deflector that matches the cutting
attachment – see "Mounting the
Deflector".
Fitting Mowing Head with Screw
Mounting
Keep the instruction leaflet for the
mowing head in a safe place.
2
1
3
002BA524 KN
2
1
002BA525 KN
1
2
002BA294 KN

Stihl FS 310 Specifications

General

Power Output	1.4 kW
Engine Type	2-stroke
Shaft Type	Straight
Sound Power Level	112 dB(A)
Engine Displacement	36.3 cc
Fuel Capacity	0.95 liters
Cutting Diameter	23-25 cm
Cutting Width	23-25 cm
Starter	Recoil