21FS 75
English / USA
: Set the choke lever (8):
For cold start to g
For warm start to e
– also use this position if the engine
has been running but is still cold.
: Press fuel pump bulb (9) at least five
times even if bulb is filled with fuel.
: Put the unit on the ground:
It must rest securely on the engine
support and deflector.
Check that the cutting tool is not
touching the ground or any other
obstacles.
: Make sure you have a firm footing.
: Hold the unit with your left hand on
the control handle and press it down
firmly – your thumb should be
under the control handle.
Do not stand or kneel on the drive
tube! This could permanently
damage the drive tube.
: Pull the starter grip slowly with your
right hand until you feel it engage –
and then give it a brisk strong pull.
Do not pull out the starter rope all
the way – it might break.
: Do not let the starter grip snap
back – guide it slowly into the
housing so that the starter rope can
rewind properly.
: Continue cranking until the engine
runs.
When engine begins to fire:
: Move choke lever to e
: Continue cranking.
As soon as engine runs:
: Blip the throttle trigger –
the slide control moves to the run
position # – and the engine returns
to idling speed.
Make sure carburetor is correctly
adjusted – the cutting tool must not
rotate when the engine is idling.
Your power tool is ready for
operation.
393BA017 KN
8
8
393BA018 KN
9
355BA007 KN
To Next Page
Loading...
