Stihl HL 100 - Working Technique; Horizontal Cut (with cutter bar at an angle); Vertical Cut (with cutter bar at an angle); Vertical Cut (with straight cutter bar)

HL 100, HL 100 K
English
13
Working Technique
Horizontal Cut (with cutter bar at an
angle)
Cutting close to the ground from a
standing position, e.g. low shrubs.
WARNING
The K version (HL 100 K) is not
approved for cutting close to the ground.
Vertical Cut (with cutter bar at an angle)
Cutting without standing directly next to
the hedge, e.g. flowerbed between
operator and hedge.
Swing the cutter bar up and down in an
arc as you move along the hedge – use
both sides of the cutting blades.
Vertical Cut (with straight cutter bar)
Extra long reach without the need for
other aids.
Swing the cutter bar up and down in an
arc as you move along the hedge – use
both sides of the cutting blades.
388BA029 KN
388BA030 KN
389BA050 KN