HLA 65
English
13
The power tool is operated with a
rechargeable battery. Use only STIHL
chargers to recharge the battery.
Data exchange
The power tool, battery and charger
communicate with each other. The
charger charges the battery and the
battery supplies the necessary power
only if data exchange functions properly.
For this reason you should operate your
power tool only with the approved STIHL
batteries and STIHL chargers.
Cutting Season
Observe country-specific or municipal
rules and regulations for cutting hedges.
Do not use your hedge trimmer during
rest periods cutomary in the
neighborhood.
Cutting Sequence
If a radical cut is necessary, cut a little at
a time in several stages.
Use lopping shears to cut out thick
branches first.
Cut the sides of the hedge first, then the
top.
Disposal
Do not throw cuttings into the garbage
can – they can be composted.
Preparations
N Adjust angle of cutter bar – see
"Adjusting the Cutter Bar"
N Remove the blade scabbard.
N Put on the harness – see "Fitting the
Harness".
N Connect machine to harbess – see
"Fitting the Harness".
Working Technique
Horizontal Cut (with cutter bar at an
angle)
Cutting close to the ground from a
standing position, e.g. low shrubs.
Swing the cutter bar back and forth in an
arc as you move along – use both sides
of the cutting blades.
The hedge trimmer is unsuitable for
mowing.
Description of Operation Using the Unit
To Next Page
Loading...
Need help?
General
