HLA 65
English
17
AL 100 charger
This charger waits for the battery to cool
down before starting the charging
process. The battery is cooled normally
by heat transfer to the ambient air.
End of charge
The charger switches itself off
automatically when the battery is fully
charged:
– Light emitting diodes on the battery
go off
– The light emitting diode on the
charger goes off
– The charger's fan is switched off (if
charger is so equipped)
Remove the charged battery from the
charger.
Four light emitting diodes show the
battery's state of charge and any
problems that occur on the battery or
power tool.
N Press button (1) to activate the
display – the display goes off
automatically after 5 seconds.
The light emitting diodes can glow or
flash green or red.
During Charging Process
The light emitting diodes glow
continuously or flash to indicate the
progress of charge.
During charging the capacity that is
currently being charged is indicated by a
green flashing light emitting diode.
When the charging process is
completed, the light emitting diodes on
the battery go off automatically.
If the light emitting diodes on the battery
flash or glow red – see "If the red light
emitting diodes glow continuously /
flash".
Light Emitting Diodes (LED)
on Battery
Light emitting diode glows con-
tinuously green.
Light emitting diode flashes
green.
Light emitting diode glows con-
tinuously red.
Light emitting diode flashes red.
3901BA016 KN
80 - 100 %
60 - 80 %
40 - 60 %
20 - 40 %
0 - 20 %
To Next Page
Loading...
Need help?
General
