HLA 65
English
30
Troubleshooting
Always remove the battery from the machine before starting any work on the machine.
Fault Cause Remedy
Machine does not start when switched on
Adjustable cutter is in transport position Swing adjustable cutter into area of
operation
No electrical contact between machine
and battery
Remove battery, visually inspect the
contacts and reinsert the battery
Battery discharged
(1 LED on battery flashes green)
Charge battery
Battery too hot / too cold
(1 LED on battery is red)
Let the battery cool down / let the battery
warm up gradually at temperatures of
approx. 15 °C - 20 °C (59°F - 68°F)
Battery fault
(4 LED on battery flashes red)
Remove battery from the machine and
reinsert it. Turn on the machine – if the
LEDs still flash, the battery is faulty and
must be replaced
Unit too hot
(3 LEDs on battery are red)
Let the machine cool off
Electromagnetic malfunction or fault in
machine
(3 LED on battery flashes red)
Remove battery from the machine and
reinsert it. Turn on machine – if the LEDs
still flash, the machine is faulty and must
be checked by a servicing dealer
1)
Moisture in the machine and/or battery Let the machine/battery dry
Machine switches off in operation
Battery or machine electronics too hot Remove battery from the machine, let
battery and machine cool off
Electrical or electromagnetic malfunction Remove battery and reinsert it
To Next Page
Loading...
Need help?
General
