EasyManuals Logo

Stihl HT 132 User Manual

Stihl HT 132
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
HT 102, HT 103, HT 132, HT 133
English
36
Checking the Spark Plug
N Clean dirty spark plug.
N Check electrode gap (A) and
readjust if necessary – see chapter
"Specifications."
N Use only resistor type spark plugs of
the approved range.
Rectify problems which have caused
fouling of spark plug:
too much oil in fuel mix,
dirty air filter,
unfavorable running conditions, e.g.
operating at part load.
WARNING
To reduce the risk of fire and burn injury,
use only spark plugs authorized by
STIHL. Always press the spark plug
boot (1) snugly onto the spark plug
terminal (2).
Do not use a spark plug with a
detachable SAE adapter terminal (3).
Arcing may occur that could ignite
combustible fumes and cause a fire.
This can result in serious injuries or
damage to property.
N Only use resistor type spark plugs
with solid, non-threaded terminals
Installing the Spark Plug
N Screw the spark plug (3) into the
cylinder.
N Tighten down the spark plug (3) with
the combination wrench.
N Press the boot (2) firmly onto the
spark plug.
N Fit the cover (1) and screw it down
firmly.
000BA039 KN
A
2
1
0000-GXX-1831-A0
3

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Stihl HT 132 and is the answer not in the manual?

Stihl HT 132 Specifications

General IconGeneral
BrandStihl
ModelHT 132
CategoryPole Saw
LanguageEnglish

Related product manuals