To Next PageTo Next Page
Need help?Do you have a question about the Stihl HT 70 and is the answer not in the manual?
General| Bar Length | 25 cm |
|---|---|
| Vibration Level Left/Right | 4.5/4.5 m/s² |
| Guide Bar Length | 25 cm |
| Total Length | 270 cm |
| Engine Type | 2-stroke gasoline |
General safety rules and warnings for operating the pole pruner.
Physical and mental condition requirements for safe operation.
General information about the pole pruner and its parts.
Steps to take before starting the pole pruner.
Instructions and warnings for adding fuel to the machine.
Procedures and precautions for starting the engine.
Important safety considerations for various working environments.
Steps for preparing to use the pole pruner, including safety gear.
Recommended order for cutting branches for efficient and safe pruning.
How to hold and position the pole pruner for effective cutting.
Technique to avoid kickback when cutting thick branches.
Method for cutting thick branches to prevent splitting.
How to prune branches that overhang obstacles.
Using the pole pruner from a lift bucket for elevated work.
Using an optional accessory for specific cutting angles.
How to verify the correct chain tension.
Adjusting the throttle cable for proper engine control.
Guidelines for mixing and storing fuel for the engine.
Step-by-step instructions and safety for refueling the machine.
Procedure for checking the chain oil level.
How to fill the oil tank for chain lubrication.
Verifying the saw chain is receiving proper oil lubrication.
Adjusting the length of the telescopic shaft on the HT 75 model.
How to properly fit and adjust the shoulder strap.
Instructions for fitting and using the full harness system.
Identification and function of the machine's controls.
Step-by-step guide to starting the engine.
Specific starting procedure for a cold engine.
Specific starting procedure for a warm engine.
Recommendations for the initial use of a new machine.
Guidelines for normal operation and chain tension checks.
How to check and adjust chain tension when cold.
How to check and adjust chain tension when warm.
Cooling down procedures after extended high-speed use.
Steps to take after completing work, including storage.
Instructions for cleaning or replacing the air filter.
Procedures for adjusting the carburetor for optimal performance.
How to inspect and maintain the spark plug.
How to check the chain sprocket for wear.
Using tools to check sharpening angles for accuracy.
Techniques for correctly sharpening the saw chain.
How to set the depth gauge for optimal cutting performance.
Procedure for lowering depth gauges when sharpening.
