15HT 70, HT 75
english
Cutting from a lift bucket
The unit's long reach enables cutting to
be performed next to the trunk without
the risk of the lift bucket damaging other
branches. The tool angle depends on
the position of the branch.
30° angle drive
(special accessory for HT 70)
The angle drive keeps the cutting
attachment at an angle of 30° to the
drive tube.
The angle drive may be adjusted on the
drive tube to the following positions only:
1: For cross-cutting vertical branches
and bushes.
2: For a better view of the cutting
attachment.
390BA017 KN
1
2
390BA053 KN
To Next Page
Loading...
Need help?
General
