Stihl HT 56 C User Manual

HT 56 C
English
38
Maintenance and Care
The following intervals apply to normal operating conditions only. If your daily work-
ing time is longer or operating conditions are difficult (very dusty work area, resin-
rich wood, tropical wood, etc.), shorten the specified intervals accordingly. If you only
use your power tool occasionally, extend the intervals accordingly.
before starting work after finishing work or daily after each refueling stop weekly monthly every 12 months if problem if damaged as required
Complete machine
Visual inspection (condition, leaks) XX
Clean X
Control handle Check operation XX
Air filter
Clean XX
Replace X
Manual fuel pump (if fitted)
Check X
Have repaired by servicing dealer
1)
X
Pickup body in fuel tank
Check X
Replace XXX
Fuel tank Clean XX
Carburetor
Check idle adjustment – chain must not
rotate
XX
Readjust idle X
Spark plug
Readjust electrode gap X
Replace after every 100 operating hours
Cooling inlets
Visual inspection X
Clean X
Spark arresting screen in muffler
Have checked by servicing dealer
1)
X
Have cleaned or replaced by servicing
dealer
1)
XX
All accessible screws and nuts (not adjust-
ing screws)
Retighten X
Chain lubrication Check X
Chain oil tank Clean XX

Stihl HT 56 C Specifications

General

Engine Power	0.8 kW (1.1 hp)
Displacement	27.2 cm³
Overall Length	280 cm
Chain Type	Picco Micro 3 (PM3)
Guide Bar Length	25 cm
Power Source	Gas
Fuel Capacity	340 cc (11.5 oz.)