25HT 70, HT 75
english
Alternative method:
: Remove the chain guard.
Position the shaft on a branch so
that it is held by the hook.
: Hold the unit firmly with your left
hand around the fan housing – your
thumb under the fan housing.
: Pull the starter grip slowly with your
right hand until you feel it engage –
and then give it a brisk strong pull.
Do not pull out starter rope to full
length – it might break.
: Do not let the starter grip snap back
– guide it slowly into the housing so
that the starter rope can rewind
properly.
When engine begins to fire:
: Move choke lever to e
: continue cranking.
As soon as engine runs:
: Blip the throttle trigger – the slide
control moves to the run position #,
and the engine returns to idling
speed.
Make sure carburetor is correctly
adjusted – chain must not run when
engine is idling.
Your pruner is ready for operation.
To shut down engine:
: Move the slide control in direction
of c to $.
390BA009 KN
To Next Page
Loading...
Need help?
General
