KB-KM, KW-KM
English
12
NOTICE
Do not stand or kneel on the drive tube.
WARNING
The sweeping attachments may begin to
rotate and cause the machine to move
as soon as the engine starts. For this
reason, blip the throttle after starting –
the engine returns to idling speed.
The starting procedure is now as
described in the instruction manual of
the KombiEngine or basic power tool
you are using.
Stopping the Engine
N See instruction manual of the
KombiEngine or basic power tool.
For periods of 3 months or longer
N Remove and clean the sweeping
attachments, inspect them for
damage and wear.
N If the KombiTool is removed from
the KombiEngine and stored
separately: Fit the protective cap on
the drive tube to avoid dirt getting
into the coupling.
N Store the machine in a dry, high or
locked location – out of the reach of
children and other unauthorized
persons.
Bristle Brush
Removing
N Remove the hitch pin (1) from the
end of the axle (2).
N Pull the bristle brush (3) off the axle.
Installing
N Push the bristle brush (3) onto the
axle.
N Insert the hitch pin (1) in the hole at
the end of the axle and fold it flat.
N Use the same procedure to mout
the other bristle brush.
WARNING
Always mount both bristle brushes.
Storing the Machine Replacing the Sweeping
Attachments
To Next Page
Loading...
Need help?
General