KB-KM, KW-KM
English
7
PowerSweep
The KW-KM PowerSweep KombiTool is
used for sweeping areas and paths,
moving wet materials, such a leaves or
dirt to a central point, clearing snow and
removing standing water from solid
surfaces.
N Push the PowerSweep steadily at
walking pace.
N Always hold and guide the tool at a
shallow angle.
WARNING
The steeper the angle shown above, the
more difficult it is to control the tool.
N Guide the PowerSweep at right
angles to the direction of travel (1).
Sweepings are thrown forwards,
ahead of the operator.
WARNING
The PowerSweep pushes back towards
the operator.
Cleaning the Sweeping Attachment
Clean away any dirt and debris that has
accumulated between the sweeping
attachments, around the gearbox or
between the sweeping attachments and
the deflector:
– Shut off the engine.
– Pull the hitch pins out of the axle.
– Remove the sweeping attachments
from the axle and clean them.
– Clean away dirt and debris from the
machine.
Refit the sweeping attachments – see
“Replacing the Sweeping Attachments”.
Only use KombiEngines supplied by
STIHL or expressly approved by STIHL
for use with the KombiTool.
This KombiTool may be operated only in
combination with the following
KombiEngines:
STIHLKM55R, KM56R, KM85R
1)
,
KM 90 R, KM 94 R, KM 100 R,
KM 110 R
1)
, KM 130 R
WARNING
Loop-handled machines must be
equipped with a barrier bar.
To Next Page
Loading...
Need help?
General