11KW
English / USA
Sweeping corners
: Turn the PowerSweep over.
Sweepings are thrown back toward the
operator. For this reason:
: Run the PowerSweep at a low
throttle setting only.
The PowerSweep pulls the operator
forward. Debris thrown back toward
the operator may affect footing.
Operation of STIHL KW PowerSweep
attachment is permitted only with the
following basic power tools:
STIHL FC 95, STIHL FC 110,
STIHL FH 75, STIHL FS 65-4
1)
,
STIHL FS 83
1)
, STIHL FS 85
1)
,
STIHL FS 90
1)
, STIHL FS 100
1)
,
STIHL FS 110
1)
, STIHL HL 73
1)
,
STIHLHL75
1)
, STIHL HL 100
1)
and
STIHL KW 85
Other combinations of the
attachment and non-approved basic
power tools are not permitted since
they may result in accidents or
serious personal injury.
Retrofitting the Loop Handle*
This attachment may be operated
only with a basic power tool
equipped with a loop handle.
The loop handle does not need to
be equipped with a barrier bar*.
The following machines must be
retrofitted with a loop handle:
0° versions of the HL 73, HL 75 and
HL 100
: To retrofit the loop handle see
“Mounting the Loop Handle”.
1)
Not approved for units with a bike
handle or models FS 85 X,
FS 110 X, HL 73 K, HL 73-0°,
HL 75 K, HL 75-0°, HL 100 K
and HL 100-0°
* see "Guide to Using this Manual"
Preparations
: Loosen the clamp screws on the
gearhead of the power tool and pull
the gearhead off the drive tube.
The drive shaft may slip out of the
tube when you pull off the gearhead.
If this happens push the drive shaft
back into the tube.
The drive shaft must not project from the
tube any more than L (7/8“ or 22 mm). If
necessary, apply slight pressure to the
drive shaft and rotate it slowly at the
same time until it can be pushed in to the
required length.
223BA028 KN
223BA029 KN
Approved Basic Power
Tools
Installing the Gearbox
402BA001 KN
381BA015 KN
L
To Next Page
Loading...
