MS 192 T, MS 192 TC
English
24
Preparations
N Thoroughly clean the oil filler cap
and the area around it to ensure that
no dirt falls into the tank.
N Position the machine so that the
filler cap is facing up.
N Open the filler cap.
Filling chain oil tank
N Refill the chain oil tank every time
you refuel.
Take care not to spill chain oil while
refilling and do not overfill the tank.
N Close the filler cap.
The saw chain must always throw off a
small amount of oil.
Every new chain has to be broken in for
about 2 to 3 minutes.
After breaking in the chain, check chain
tension and adjust if necessary – see
"Checking Chain Tension".
Filling Chain Oil Tank
There must still be a small amount
of oil in the oil tank when the fuel
tank is empty.
If the oil level in the tank does not
go down, the reason may be a
fault in the oil supply system:
Check chain lubrication, clean the
oilways, contact your dealer for
assistance if necessary STIHL
recommends that you have
servicing and repair work carried
out exclusively by an authorized
STIHL servicing dealer.
Checking Chain
Lubrication
Never operate your saw without
chain lubrication. If the chain runs
dry, the whole cutting attachment
will be irretrievably damaged
within a very short time. Always
check chain lubrication and the oil
level in the tank before starting
work.
To Next Page
Loading...
Need help?
General
