Stihl MS 192 TC

MS 192 T, MS 192 TC
English
26
The three positions of the Master
Control lever:
Stop 0 – engine off – the ignition is
switched off.
Normal run position F – engine runs or
can fire.
To move the Master Control lever from F
to n, press down the throttle trigger
lockout and squeeze the throttle trigger
at the same time.
Starting throttle position n – this
position is used to start a warm engine.
The Master Control lever moves to the
normal run position as soon as the
throttle trigger is squeezed.
Starting the engine
N Observe safety precautions.
N Press the fuel pump bulb at least
five times – even if the bulb is
already filled with fuel.
N Push the hand guard (1) forward –
the chain is locked.
N Press down the throttle trigger
lockout (2) and squeeze the throttle
trigger (3) at the same time – hold
both levers in that position.
N Move the Master Control lever (4) to
n and hold it there.
N Now release the throttle trigger,
Master Control and trigger lockout in
that order. This is the starting
throttle position.
If the engine is cold
N Set the choke lever (5) to l.
If the engine is warm
N Set the choke lever (5) to
j . Also
use this position if the engine has
been running but is still cold.
Information Before You
Start
151BA006 KN
STOP
Starting / Stopping the
Engine