MS 192 T, MS 192 TC
English
28
N Pull the hand guard back toward the
handlebar. The chain brake is now
disengaged – your saw is ready for
operation.
N Always check operation of chain
lubrication before starting work.
At very low outside temperatures
N Open throttle slightly – warm up the
engine for a short period.
Shutting down the engine
N Move the Master Control lever to 0
or STOP.
If fuel tank has been run completely
dry and then refueled
N After refueling, press the fuel pump
bulb at least five times – even if the
bulb is filled with fuel.
If the engine does not start
Engine is flooded
If you did not move the choke lever to
warm start j quickly enough after the
engine began to fire, the combustion
chamber is flooded.
N Move the Master Control lever to 0
or STOP.
N Open the twist lock (1) in the
direction of the arrow.
N Remove the carburetor box
cover (2).
N Insert a suitable tool in the spark
plug boot (3).
N Pry off the spark plug boot.
N Unscrew and dry off the spark plug.
N Open the throttle wide.
N Set the choke lever to j (warm
start).
As the chain brake is still
engaged, the engine must be
returned to idling speed
immediately or the engine housing
and chain brake might otherwise
be damaged.
Always disengage chain brake
before accelerating the engine.
High revs with the chain brake
engaged (chain locked) will
quickly damage the powerhead
and chain drive (clutch, chain
brake).
To Next Page
Loading...
Need help?
General
