32
English / USA
MS 200
: Thoroughly clean the the oil fille cap
and the area round it to ensure that
no dirt falls into the tank.
: Remove the filler cap
: Refill the chain oil tank every time
you refuel.
: Close the filler cap
There must still be a small amount of oil
in the oil tank when the fuel tank is
empty.
If the oil tank is still partly full, the reason
may be a problem in the oil supply
system: Check chain lubrication, clean
the oilways, contact your STlHL dealer
for assistance if necessary.
The saw chain must always throw off a
small amount of oil.
Never operate your saw without
chain lubrication. If the chain runs
dry, the whole cutting attachment
will be irretrievably damaged within
a very short time.
Always check chain lubrication and
oil level in tank before starting work.
Every new chain has to be broken in for
about 2 to 3 minutes.
After breaking in chain, check chain
tension and adjust if necessary – see
“Checking Chain Tension”.
Locking chain with chain brake
– in an emergency
– when starting
– at idling speed
The chain is stopped and locked when
the hand guard is pushed toward the bar
nose by the left hand –
or when brake is activated by inertia in
certain kickback situations.
Filling Chain
Oil Tank
161BA004 KN
Checking Chain Lubrication
143BA024 KN
Chain Brake
161BA005 KN
To Next Page
Loading...
Need help?
General
