Stihl MS 200 User Manual

40
English / USA
MS 200
: Lift air filter and pull it away to the
rear.
: Press end of air filter against a flat
surface – this pushes the filter cover
upward.
: Wash the filter in a clean, non-
flammable solution (e.g. warm
soapy water) and then dry.
: Always replace a damaged filter.
: Refit the filter cover (peg must snap
into position) and then install the
filter.
Exhaust emissions are controlled by the
design of the fundamental engine
parameters and components (e.g.
carburation, ignition, timing and valve or
port timing) without the addition of any
major hardware.
144BA010 KN
144BA019 KN
Motor Management

Stihl MS 200 Specifications

General

Guide Bar Length	30-40 cm
Chain Oil Capacity	0.22 L
Chain pitch	3/8"
Engine Power	2.0 kW
Displacement	35.2 cc
Weight (without cutting equipment)	4.2 kg