Stihl MS 200

57MS 200
English / USA
Cutting Attachment
Recommended cutting attachments
for compliance with § 5.11 of ANSI
Standard B 175.1-2000
(see page 14 of this Manual):
STIHL reduced kickback bars
(with green label)
Rollomatic with sprocket nose for 3/8" P
(9.32 mm) pitch:
12, 14, 16 or 18 in (30, 35, 40 or 45 cm)
Rollomatic Light with sprocket nose for
3/8" P (9.32 mm) pitch: 14 in (35 cm)
STIHL low kickback chain*
(with green label) for 3/8" P pitch: 3/8" P
(9.32 mm) Picco-Micro 1 (63 PM 1)
Chain sprocket:
6-tooth for 3/8" P pitch spur sprocket
In order to comply with the kickback
performance requirements of § 5.11
of ANSI Standard B 175.1-2000,
do not use replacement saw chain
unless it has been designated as
meeting the ANSI § 5.11 requirements
on this specific powerhead, or has been
designated as "low kickback" saw chain*
in accordance with the
ANSI B 175.1-2000 standard.
* See definition of "low kickback
chain"on page 16 of this Manual.
Since new bar/chain combinations may
be developed after publication of this
Manual, ask your STIHL dealer for the
latest STIHL recommendations.
Other STIHL yellow-labeled chains
available for this powerhead are:
Picco-Micro (63 PM)
File holder with round file
Filing gauge
Reference gauges
STIHL lubricating grease
STIHL filler nozzle for STIHL
canisters
helps avoid spills and overfilling during
refueling.
Contact your STIHL dealer for more
information on these and other special
accessories.
Special Accessories