41MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
English / USA
: Lift out the shutter (in front of spark
plug) vertically.
: Turn the shutter 180°.
: Refit the shutter.
: Refit the carburetor box cover and
secure it the twist lock.
Heated air is now drawn in from around
the cylinder and mixed with cold air –
this helps prevent carburetror icing.
At temperatures above +20°C/70°F,
always close the shutter again. This
is important to avoid engine running
problems, i.e. overheating.
The four positions of the
Master Control lever
$ = Engine off –
ignition is switched off.
# = Normal run position –
engine runs or can fire.
To move the Master Control lever from #
to
n or l, press down the throttle
trigger interlock and squeeze throttle
trigger at the same time.
n=Warm start – this position is used to
start a warm engine. The Master
Control lever moves to the normal
run position as soon as the throttle
trigger is squeezed.
l=Cold start – this position is used to
start a cold engine.
Models with fuel pump
: Prime the fuel system by pressing
the fuel pump bulb about five times.
Press a few times more if you are
starting for the first time after refilling a
dry tank.
135BA029 LÄ
Information
Before You Start
STOP
0
001BA140 KN
Starting / Stopping
the Engine
135BA027 KN
To Next Page
Loading...
