Stihl MS441 C-M User Manual

MS 441 C-M
English
29
N To correct a misalignment, turn the
cap (with the grip up) until it drops
fully into the tank opening.
N Twist the cap counterclockwise as
far as it will go (approx. 1/4 turn) –
this will twist the base of the cap into
the correct position.
N Twist the cap clockwise, closing it
normally – see the sections
"Closing" and "Checking for proper
closure."
N If your cap still does not tighten
properly, it may be damaged or
broken; immediately stop use of the
unit and take it to your authorized
STIHL dealer for repair.
Filler cap with markings and symbols
Opening
N Raise handle.
N Twist filler cap counterclockwise
(approx. 1/4 turn).
Markings on filler cap and housing must
align.
N Remove the filler cap.
Refueling
Take care not to spill fuel while fueling
and do not overfill the tank – leave
approx. 1/2" (13 mm) air space.
Closing
Handle is in an upright position:
N Position filler cap – markings on filler
cap and housing must align.
N Push the filler cap down as far as it
will go.
N Push the filler cap down and twist it
clockwise until it engages.
Then the markings on filler cap and
housing will align.
001BA226 KN
001BA236 KN
001BA232 KN
001BA234 KN
001BA237 KN
001BA234 KN
001BA233 KN
001BA231 KN

Stihl MS441 C-M Specifications

General

Displacement	70.7 cc
Chain oil automatic adjustment	Yes
Vibration damping	Yes
Starter	STIHL ElastoStart
Engine Power	5.6 bhp
Guide Bar Lengths	40 to 71 cm (16 to 28 in.)
STIHL Oilomatic chain pitch	3/8"
Ignition system	Electronic
Fuel Capacity	24.5 oz
Chain Oil Capacity	12.2 oz